MC68HC05JJ6 Datasheet, PDF (113/216 Pages) Freescale Semiconductor, Inc – General Release Specification Microcontrollers

Analog Subsystem
ICEN
This is a read/write bit that enables a voltage comparison to trigger the
input capture register of the programmable timer when the CPF2 flag
bit is set. Therefore, an A/D conversion could be started by receiving
an OCF or TOF from the programmable timer and then terminated
when the voltage on the external ramping capacitor reaches the level
of the unknown voltage. The time of termination will be stored in the
16-bit buffer located at $0014 and $0015. This bit is automatically set
whenever mode 2 or mode 3 is selected by setting the ATD2 control
bit. This bit is cleared by a reset of the device.
1 = Connects the CPF2 flag bit to the timer input capture register
0 = Connects the PB3/AN3 pin to the timer input capture register
NOTE: For the input capture to occur when the output of comparator 2 goes
high, the IEDG bit in the TCR must also be set.
When the ICEN bit is set, the input capture function of the programmable
timer is not connected to the PB3/AN3/TCAP pin but is driven by the
CPF2 output flag from comparator 2. To return to capturing times from
external events, the ICEN bit must first be cleared before the timed event
occurs.
CPIE
This is a read/write bit that enables an analog interrupt when either of
the CPF1 or CPF2 flag bits is set to a logical one. This bit is cleared
by a reset of the device.
1 = Enables analog interrupts when comparator flag bits are set
0 = Disables analog interrupts when comparator flag bits are set
NOTE:
If both the ICEN and CPIE bits are set, they will both generate an
interrupt by different paths. One will be the programmable timer interrupt
due to the input capture; and the other will be the analog interrupt due to
the output of comparator 2 going high. In this case, the input capture
interrupt will be entered first due to its higher priority. The analog
interrupt will then need to be serviced even if the comparator 2 output
has been reset or the input capture flag (ICF) has been cleared.
MC68HC05JJ6/MC68HC05JP6 — Rev. 3.2
Freescale Semiconductor
Analog Subsystem
General Release Specification
113