MC68HC05JJ6 Datasheet, PDF (141/216 Pages) Freescale Semiconductor, Inc – General Release Specification Microcontrollers

Simple Serial Interface
9.4 SIOP Registers
The SIOP is programmed and controlled by the SIOP control register
(SCR) located at address $000A, the SIOP status register (SSR) located
at address $000B, and the SIOP data register (SDR) located at address
$000C.
9.4.1 SIOP Control Register
The SIOP control register (SCR) is located at address $000A and
contains seven control bits and a write-only reset of the interrupt flag.
Figure 9-4 shows the position of each bit in the register and indicates
the value of each bit after reset.
$000A
Read:
Write:
Reset:
Bit 7
6
5
4
3
2
1
0
SPIE SPE LSBF MSTR
CPHA SPR1
SPIR
0
0
0
0
0
0
0
Figure 9-4. SIOP Control Register (SCR)
Bit 0
SPR0
0
SPIE — Serial Peripheral Interrupt Enable
The SPIE bit enables the SIOP to generate an interrupt whenever the
SPIF flag bit in the SSR is set. Clearing the SPIE bit will not affect the
state of the SPIF flag bit and will not terminate a serial interrupt once
the interrupt sequence has started. Reset clears the SPIE bit.
1 = Serial interrupt enabled
0 = Serial interrupt disabled
NOTE:
If the SPIE bit is cleared just after the serial interrupt sequence has
started (for instance, the CPU status is being stacked), then the CPU will
be unable to determine the source of the interrupt and will vector to the
reset vector as a default.
MC68HC05JJ6/MC68HC05JP6 — Rev. 3.2
Freescale Semiconductor
Simple Serial Interface
General Release Specification
141