MC68HC05JJ6 Datasheet, PDF (143/216 Pages) Freescale Semiconductor, Inc – General Release Specification Microcontrollers

Simple Serial Interface
SPIR — Serial Peripheral Interrupt Reset
The SPIR bit is a write-only control to reset the SPIF flag bit in the
SSR. Reading the SPIR bit will return a logical zero.
1 = Reset the SPIF flag bit
0 = No effect
CPHA — Clock Phase
The CPHA bit controls the clock timing and phase in the SIOP. Data
is changed on the falling edge of SCK and data is captured (read) on
the rising edge of SCK. This bit is cleared by reset.
1 = SCK idle low
0 = SCK idle high
SPR0:SPR1 — Serial Peripheral Clock Rate Selects
The SPR0 and SPR1 bits select one of four clock rates given in Table
9-1 to be supplied on the PB7/SCK pin when the device is configured
with the SIOP as a master (MSTR = 1). The fastest rate is when both
SPR0 and SPR1 are set. Both the SPR0 and SPR1 bits are cleared
by reset, which places the SIOP clock selection at the slowest rate.
Table 9-1. SIOP Clock Rate Selection
SPR1
0
0
1
1
SPR0
0
1
0
1
SIOP Clock Rate
(Oscillator Frequency
Divided by:)
64
32
16
8
MC68HC05JJ6/MC68HC05JP6 — Rev. 3.2
Freescale Semiconductor
Simple Serial Interface
General Release Specification
143