SAM7X256_14 Datasheet, PDF (58/662 Pages) ATMEL Corporation – ARM-based Flash MCU

13.2.4 Reset States
The Reset State Manager handles the different reset sources and generates the internal reset signals. It reports the reset
status in the field RSTTYP of the Status Register (RSTC_SR). The update of the field RSTTYP is performed when the
processor reset is released.
13.2.4.1 Power-up Reset
When VDDCORE is powered on, the Main Supply POR cell output is filtered with a start-up counter that operates at Slow
Clock. The purpose of this counter is to ensure that the Slow Clock oscillator is stable before starting up the device.
The startup time, as shown in Figure 13-4, is hardcoded to comply with the Slow Clock Oscillator startup time. After the
startup time, the reset signals are released and the field RSTTYP in RSTC_SR reports a Power-up Reset.
When VDDCORE is detected low by the Main Supply POR Cell, all reset signals are asserted immediately.
Figure 13-4. Power-up Reset
SLCK
MCK
Any
Freq.
Main Supply
POR output
proc_nreset
Startup Time
Processor Startup
= 3 cycles
periph_nreset
NRST
(nrst_out)
EXTERNAL RESET LENGTH
= 2 cycles
SAM7X Series [DATASHEET] 58
6120K–ATARM–11-Feb-14