SAM7X256_14 Datasheet, PDF (452/662 Pages) ATMEL Corporation – ARM-based Flash MCU

34.6.6 UDP Interrupt Mask Register
Register Name:
UDP_ IMR
Access Type:
Read-only
31
30
29
28
27
26
25
24
–
–
–
–
–
–
–
–
23
22
21
20
19
18
17
16
–
–
–
–
–
–
–
–
15
14
13
12
11
10
9
8
–
–
WAKEUP
–
SOFINT
–
RXRSM
RXSUSP
7
6
5
4
3
2
1
0
EP5INT
EP4INT
EP3INT
EP2INT
EP1INT
EP0INT
• EP0INT: Mask Endpoint 0 Interrupt
• EP1INT: Mask Endpoint 1 Interrupt
• EP2INT: Mask Endpoint 2 Interrupt
• EP3INT: Mask Endpoint 3 Interrupt
• EP4INT: Mask Endpoint 4 Interrupt
• EP5INT: Mask Endpoint 5 Interrupt
0 = Corresponding Endpoint Interrupt is disabled.
1 = Corresponding Endpoint Interrupt is enabled.
• RXSUSP: Mask UDP Suspend Interrupt
0 = UDP Suspend Interrupt is disabled.
1 = UDP Suspend Interrupt is enabled.
• RXRSM: Mask UDP Resume Interrupt.
0 = UDP Resume Interrupt is disabled.
1 = UDP Resume Interrupt is enabled.
• SOFINT: Mask Start Of Frame Interrupt
0 = Start of Frame Interrupt is disabled.
1 = Start of Frame Interrupt is enabled.
• BIT12: UDP_IMR Bit 12
Bit 12 of UDP_IMR cannot be masked and is always read at 1.
• WAKEUP: USB Bus WAKEUP Interrupt
0 = USB Bus Wakeup Interrupt is disabled.
1 = USB Bus Wakeup Interrupt is enabled.
Note:
When the USB block is in suspend mode, the application may power down the USB logic. In this case, any USB
HOST resume request that is made must be taken into account and, thus, the reset value of the RXRSM bit of the
register UDP_ IMR is enabled.
SAM7X Series [DATASHEET]
6120K–ATARM–11-Feb-14
452