PIC18F6390 Datasheet, PDF (365/412 Pages) Microchip Technology – 64/80-Pin Flash Microcontrollers with LCD Driver and nanoWatt Technology

PIC18F6390/6490/8390/8490
26.3 DC Characteristics: PIC18F6390/6490/8390/8490 (Industrial)
PIC18LF6390/6490/8390/8490 (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Param
No.
Symbol
Characteristic
Min
Max Units
Conditions
VIL
Input Low Voltage
I/O ports:
D030
with TTL buffer
VSS
0.15 VDD V VDD < 4.5V
D030A
—
0.8
V 4.5V ≤ VDD ≤ 5.5V
D031
with Schmitt Trigger buffer
RC3 and RC4
VSS
0.2 VDD V
VSS
0.3 VDD V
D032
MCLR
VSS
0.2 VDD V
D032A
D033
OSC1 and T1OSI
OSC1
VSS
0.3 VDD V LP, XT, HS, HSPLL
modes⁽¹⁾
VSS
0.2 VDD V EC mode⁽¹⁾
VIH Input High Voltage
I/O ports:
D040
with TTL buffer
0.25 VDD + 0.8V VDD
V VDD < 4.5V
D040A
2.0
VDD
V 4.5V ≤ VDD ≤ 5.5V
D041
with Schmitt Trigger buffer
RC3 and RC4
0.8 VDD
0.7 VDD
VDD
V
VDD
V
D042
MCLR
0.8 VDD
VDD
V
D042A
D043
OSC1 and T1OSI
OSC1
0.7 VDD
0.8 VDD
VDD
V LP, XT, HS, HSPLL
modes⁽¹⁾
VDD
V EC mode⁽¹⁾
IIL
Input Leakage Current^(2,3)
D060
I/O ports
—
±1
µA VSS ≤ VPIN ≤ VDD,
Pin at hi-impedance
D061
MCLR
—
±5
µA VSS ≤ VPIN ≤ VDD
D063
OSC1
—
±5
µA VSS ≤ VPIN ≤ VDD
IPU
Weak Pull-up Current
D070 IPURB PORTB weak pull-up current
50
400
µA VDD = 5V, VPIN = VSS
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PICmicro^® device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Parameter is characterized but not tested.
 2004 Microchip Technology Inc.
Preliminary
DS39629B-page 363