BD82QM67-SLJ4M Datasheet, PDF (656/934 Pages) Intel Corporation – Intel® 6 Series Chipset and Intel® 6 Series Chipset and

EHCI Controller Registers (D29:F0, D26:F0)
16.1.29 SPECIAL_SMI—Intel Specific USB 2.0 SMI Register
(USB EHCI—D29:F0, D26:F0)
Address Offset:
Default Value:
Power Well:
Function Level Reset:
70h–73h
00000000h
Suspend
No
Attribute:
Size:
R/W, R/WC
32 bits
Note:
These bits are not reset by a D3-to-D0 warm rest or a core well reset.
Bit D
31:25
24:22
21
20
19
18
17
16
15:14
13:6
5
4
escription
Reserved.
SMI on PortOwner — R/WC. Software clears these bits by writing a 1 to it.
0 = No Port Owner bit change.
1 = Bits 24:22 correspond to the Port Owner bits for ports 0 (22) through 3 (24).
These bits are set to 1 when the associated Port Owner bits transition from 0
to 1 or 1 to 0.
SMI on PMCSR — R/WC. Software clears these bits by writing a 1 to it.
0 = Power State bits Not modified.
1 = Software modified the Power State bits in the Power Management Control/
Status (PMCSR) register (D29:F0, D26:F0:54h).
SMI on Async — R/WC. Software clears these bits by writing a 1 to it.
0 = No Async Schedule Enable bit change
1 = Async Schedule Enable bit transitioned from 1 to 0 or 0 to 1.
SMI on Periodic — R/WC. Software clears this bit by writing a 1 it.
0 = No Periodic Schedule Enable bit change.
1 = Periodic Schedule Enable bit transitions from 1 to 0 or 0 to 1.
SMI on CF — R/WC. Software clears this bit by writing a 1 it.
0 = No Configure Flag (CF) change.
1 = Configure Flag (CF) transitions from 1 to 0 or 0 to 1.
SMI on HCHalted — R/WC. Software clears this bit by writing a 1 it.
0 = HCHalted did Not transition to 1 (as a result of the Run/Stop bit being
cleared).
1 = HCHalted transitions to 1 (as a result of the Run/Stop bit being cleared).
SMI on HCReset — R/WC. Software clears this bit by writing a 1 it.
0 = HCRESET did Not transitioned to 1.
1 = HCRESET transitioned to 1.
Reserved
SMI on PortOwner Enable — R/W.
0 = Disable.
1 = Enable. When any of these bits are 1 and the corresponding SMI on
PortOwner bits are 1, then the host controller will issue an SMI. Unused
ports should have their corresponding bits cleared.
SMI on PMSCR Enable — R/W.
0 = Disable.
1 = Enable. When this bit is 1 and SMI on PMSCR is 1, then the host controller
will issue an SMI.
SMI on Async Enable — R/W.
0 = Disable.
1 = Enable. When this bit is 1 and SMI on Async is 1, then the host controller will
issue an SMI
656
Datasheet