MC908KX2MDWE Datasheet, PDF (50/210 Pages) Freescale Semiconductor, Inc – High-performance M68HC08 architecture, Fully upward-compatible object code with M6805, M146805, and M68HC05 Families

Configuration Register (CONFIG)
LVIPWRD — LVI Power Disable Bit
LVIPWRD disables the LVI module. See Chapter 10 Low-Voltage Inhibit (LVI).
1 = LVI module power disabled
0 = LVI module power enabled
LVI5OR3 — LVI 5-V or 3-V Operating Mode Bit
LVI5OR3 selects the voltage operating mode of the LVI module (see See Chapter 10 Low-Voltage
Inhibit (LVI).). The voltage mode selected for the LVI should match the operating V_DD. See Chapter 17
Electrical Specifications for the LVI’s voltage trip points for each of the modes.
1 = LVI operates in 5-V mode.
0 = LVI operates in 3-V mode.
NOTE
The LVI5OR3 bit is cleared by a power-on reset (POR) only. Other resets
will leave this bit unaffected.
SSREC — Short Stop Recovery Bit
SSREC enables the CPU to exit stop mode with a delay of 32 CGMXCLK cycles instead of a
4096-CGMXCLK cycle delay.
1 = Stop mode recovery after 32 CGMXCLK cycles
0 = Stop mode recovery after 4096 CGMXCLCK cycles
NOTE
Exiting stop mode by an LVI reset will result in the long stop recovery.
If the system clock source selected is the internal oscillator or the external crystal and the
OSCENINSTOP configuration bit is not set, the oscillator will be disabled during stop mode. The short
stop recovery does not provide enough time for oscillator stabilization and thus the SSREC bit should
not be set.
When using the LVI during normal operation but disabling during stop mode, the LVI will have an
enable time of t_EN. The system stabilization time for power-on reset and long stop recovery (both 4096
CGMXCLK cycles) gives a delay longer than the LVI enable time for these startup scenarios. There is
no period where the MCU is not protected from a low-power condition. However, when using the short
stop recovery configuration option, the 32-CGMXCLK delay must be greater than the LVI’s turn on time
to avoid a period in startup where the LVI is not protecting the MCU.
STOP — STOP Instruction Enable Bit
STOP enables the STOP instruction.
1 = STOP instruction enabled
0 = STOP instruction treated as illegal opcode
COPD — COP Disable Bit
COPD disables the COP module. See Chapter 5 Computer Operating Properly Module (COP).
1 = COP module disabled
0 = COP module enabled
MC68HC908KX8 • MC68HC908KX2 • MC68HC08KX8 Data Sheet, Rev. 2.1
50
Freescale Semiconductor