MC908KX2MDWE Datasheet, PDF (130/210 Pages) Freescale Semiconductor, Inc – High-performance M68HC08 architecture, Fully upward-compatible object code with M6805, M146805, and M68HC05 Families

Serial Communications Interface Module (SCI)
PEIE — Receiver Parity Error Interrupt Enable Bit
This read/write bit enables SCI receiver CPU interrupt requests generated by the parity error bit, PE.
Reset clears PEIE.
1 = SCI error CPU interrupt requests from PE bit enabled
0 = SCI error CPU interrupt requests from PE bit disabled
NOTE
Bits 5 and 4 are reserved for MCUs with a direct-memory access (DMA)
module. Because the MC68HC908KX8 does not have a DMA module,
these bits should not be set.
12.7.4 SCI Status Register 1
SCI status register 1 (SCS1) contains flags to signal these conditions:
• Transfer of SCDR data to transmit shift register complete
• Transmission complete
• Transfer of receive shift register data to SCDR complete
• Receiver input idle
• Receiver overrun
• Noisy data
• Framing error
• Parity error
Address: $0016
Bit 7
6
5
4
3
2
1
Bit 0
Read: SCTE
TC
SCRF
IDLE
OR
NF
FE
PE
Write:
Reset: 1
1
0
0
0
0
0
0
= Unimplemented
Figure 12-13. SCI Status Register 1 (SCS1)
SCTE — SCI Transmitter Empty Bit
This clearable, read-only bit is set when the SCDR transfers a character to the transmit shift register.
SCTE can generate an SCI transmitter CPU interrupt request. When the SCTIE bit in SCC2 is set,
SCTE generates an SCI transmitter CPU interrupt request. In normal operation, clear the SCTE bit by
reading SCS1 with SCTE set and then writing to SCDR. Reset sets the SCTE bit.
1 = SCDR data transferred to transmit shift register
0 = SCDR data not transferred to transmit shift register
TC — Transmission Complete Bit
This read-only bit is set when the SCTE bit is set, and no data, preamble, or break character is being
transmitted. TC generates an SCI transmitter CPU interrupt request if the TCIE bit in SCC2 is also set.
TC is cleared automatically when data, preamble, or break is queued and ready to be sent. There may
be up to 1.5 transmitter clocks of latency between queueing data, preamble, and break and the
transmission actually starting. Reset sets the TC bit.
1 = No transmission in progress
0 = Transmission in progress
MC68HC908KX8 • MC68HC908KX2 • MC68HC08KX8 Data Sheet, Rev. 2.1
130
Freescale Semiconductor