MC68HC908GP32_08 Datasheet, PDF (81/266 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

Chapter 6
Configuration Register (CONFIG)
6.1 Introduction
This section describes the configuration registers, CONFIG1 and CONFIG2. The configuration registers
enable or disable these options:
• Stop mode recovery time (32 CGMXCLK cycles or 4096 CGMXCLK cycles)
• COP timeout period (262,128 or 8176 CGMXCLK cycles)
• STOP instruction
• Computer operating properly module (COP)
• Low-voltage inhibit (LVI) module control and voltage trip point selection
• Enable/disable the oscillator (OSC) during stop mode
6.2 Functional Description
The configuration registers are used in the initialization of various options. The configuration registers can
be written once after each reset. All of the configuration register bits are cleared during reset. Since the
various options affect the operation of the MCU, it is recommended that these registers be written
immediately after reset. The configuration registers are located at $001E and $001F. The configuration
register may be read at anytime.
NOTE
On a FLASH device, the options except LVI5OR3 are one-time writeable
by the user after each reset. The LVI5OR3 bit is one-time writeable by the
user only after each POR (power-on reset). The CONFIG registers are not
in the FLASH memory but are special registers containing one-time
writeable latches after each reset. Upon a reset, the CONFIG registers
default to predetermined settings as shown in Figure 6-1 and Figure 6-2.
Address: $001E
Bit 7
6
5
4
3
2
1
Bit 0
Read: 0
0
0
0
0
0
OSCSTOPENB SCIBDSRC
Write:
Reset: 0
0
0
0
0
0
0
0
= Unimplemented
Figure 6-1. Configuration Register 2 (CONFIG2)
MC68HC908GP32 Data Sheet, Rev. 10
Freescale Semiconductor
81