MC68HC908GP32_08 Datasheet, PDF (153/266 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

I/O Registers
Address: $0017
Bit 7
6
5
4
3
2
1
Bit 0
Read:
BKF
RPF
Write:
Reset: 0
0
0
0
0
0
0
0
= Unimplemented
Figure 13-14. SCI Status Register 2 (SCS2)
BKF — Break Flag Bit
This clearable, read-only bit is set when the SCI detects a break character on the PTE1/RxD pin. In
SCS1, the FE and SCRF bits are also set. In 9-bit character transmissions, the R8 bit in SCC3 is
cleared. BKF does not generate a CPU interrupt request. Clear BKF by reading SCS2 with BKF set
and then reading the SCDR. Once cleared, BKF can become set again only after logic 1s again appear
on the PTE1/RxD pin followed by another break character. Reset clears the BKF bit.
1 = Break character detected
0 = No break character detected
RPF — Reception in Progress Flag Bit
This read-only bit is set when the receiver detects a logic 0 during the RT1 time period of the start bit
search. RPF does not generate an interrupt request. RPF is reset after the receiver detects false start
bits (usually from noise or a baud rate mismatch) or when the receiver detects an idle character. Polling
RPF before disabling the SCI module or entering stop mode can show whether a reception is in
progress.
1 = Reception in progress
0 = No reception in progress
13.8.6 SCI Data Register
The SCI data register (SCDR) is the buffer between the internal data bus and the receive and transmit
shift registers. Reset has no effect on data in the SCI data register.
Address: $0018
Bit 7
6
Read: R7
R6
Write: T7
T6
Reset:
5
4
3
2
R5
R4
R3
R2
T5
T4
T3
T2
Unaffected by reset
1
Bit 0
R1
R0
T1
T0
Figure 13-15. SCI Data Register (SCDR)
R7/T7–R0/T0 — Receive/Transmit Data Bits
Reading the SCDR accesses the read-only received data bits, R7:R0. Writing to the SCDR writes the
data to be transmitted, T7:T0. Reset has no effect on the SCDR.
NOTE
Do not use read/modify/write instructions on the SCI data register.
13.8.7 SCI Baud Rate Register
The baud rate register (SCBR) selects the baud rate for both the receiver and the transmitter.
MC68HC908GP32 Data Sheet, Rev. 10
Freescale Semiconductor
153