English
Language : 

MC68HC908GP32_08 Datasheet, PDF (199/266 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers
Chapter 17
Timer Interface Module (TIM)
17.1 Introduction
This section describes the timer interface (TIM) module. The TIM is a two-channel timer that provides a
timing reference with input capture, output compare, and pulse-width-modulation functions. Figure 17-1
is a block diagram of the TIM.
This particular MCU has two timer interface modules which are denoted as TIM1 and TIM2.
17.2 Features
Features of the TIM include:
• Two input capture/output compare channels:
– Rising-edge, falling-edge, or any-edge input capture trigger
– Set, clear, or toggle output compare action
• Buffered and unbuffered pulse-width-modulation (PWM) signal generation
• Programmable TIM clock input with 7-frequency internal bus clock prescaler selection
• Free-running or modulo up-count operation
• Toggle any channel pin on overflow
• TIM counter stop and reset bits
17.3 Pin Name Conventions
The text that follows describes both timers, TIM1 and TIM2. The TIM input/output (I/O) pin names are
T[1,2]CH0 (timer channel 0) and T[1,2]CH1 (timer channel 1), where “1” is used to indicate TIM1 and “2”
is used to indicate TIM2. The two TIMs share four I/O pins with four port D I/O port pins. The full names
of the TIM I/O pins are listed in Table 17-1. The generic pin names appear in the text that follows.
Table 17-1. Pin Name Conventions
TIM Generic Pin Names:
Full TIM
Pin Names:
TIM1
TIM2
T[1,2]CH0
PTD4/T1CH0
PTD6/T2CH0
T[1,2]CH1
PTD5/T1CH1
PTD7/T2CH1
NOTE
References to either timer 1 or timer 2 may be made in the following text by
omitting the timer number. For example, TCH0 may refer generically to
T1CH0 and T2CH0, and TCH1 may refer to T1CH1 and T2CH1.
MC68HC908GP32 Data Sheet, Rev. 10
Freescale Semiconductor
199