MC9S12E128CFUE Datasheet, PDF (577/606 Pages) Freescale Semiconductor, Inc – MC9S12E128 Data Sheet

Appendix A Electrical Characteristics
A.3.3 Phase Locked Loop
The oscillator provides the reference clock for the PLL. The PLL´s Voltage Controlled Oscillator (VCO)
is also the system clock source in self clock mode.
A.3.3.1 XFC Component Selection
This section describes the selection of the XFC components to achieve a good filter characteristics.
C_p
VDDPLL
C_s
R
Phase
XFC Pin
VCO
f_osc
1
f_ref
refdv+1
∆
K_Φ
K_V
f_vco
Detector
f_cmp
Loop Divider
1
1
synr+1
2
Figure A-2. Basic PLL functional diagram
The following procedure can be used to calculate the resistance and capacitance values using typical values
for K₁, f₁ and i_ch from Table A-13.
The grey boxes show the calculation for f_VCO = 50MHz and f_ref = 1MHz. E.g., these frequencies are used
for f_OSC = 4MHz and a 25MHz bus clock.
The VCO Gain at the desired VCO frequency is approximated by:
K_V = K₁ ⋅ e^{-(--fK--1--1--–--⋅--f-1-v---cV--o-}₌^--) _{–100 ⋅ e}^{(---6---–0---1-–--0---50---0---}₌^-) _-90.48MHz/V
The phase detector relationship is given by:
K_Φ = – i_ch ⋅ K_V
= 316.7Hz/Ω
i_ch is the current in tracking mode.
MC9S12E128 Data Sheet, Rev. 1.07
Freescale Semiconductor
577