MC68HC08AB16A Datasheet, PDF (142/380 Pages) Motorola, Inc – HCMOS Microcontroller Unit

Freescale Semiconductor, Inc.
Clock Generator Module (CGM)
9.7 Interrupts
When the AUTO bit is set in the PLL bandwidth control register
(PBWC), the PLL can generate a CPU interrupt request every time the
LOCK bit changes state. The PLLIE bit in the PLL control register
(PCTL) enables CPU interrupts from the PLL. PLLF, the interrupt flag in
the PCTL, becomes set whether interrupts are enabled or not. When
the AUTO bit is clear, CPU interrupts from the PLL are disabled and
PLLF reads as 0.
Software should read the LOCK bit after a PLL interrupt request to see
if the request was due to an entry into lock or an exit from lock. When
the PLL enters lock, the VCO clock CGMVCLK, divided by two can be
selected as the CGMOUT source by setting BCS in the PCTL. When
the PLL exits lock, the VCO clock frequency is corrupt, and appropriate
precautions should be taken. If the application is not frequency-
sensitive, interrupts should be disabled to prevent PLL interrupt service
routines from impeding software performance or from exceeding stack
limitations.
NOTE:
Software can select CGMVCLK/2 as the CGMOUT source even if the
PLL is not locked (LOCK = 0). Therefore, software should make sure the
PLL is locked before setting the BCS bit.
9.8 Low-Power Modes
The WAIT and STOP instructions put the MCU in low-power-
consumption standby modes.
9.8.1 Wait Mode
The WAIT instruction does not affect the CGM. Before entering WAIT
mode, software can disengage and turn off the PLL by clearing the BCS
and PLLON bits in the PLL control register (PCTL). Less power-
sensitive applications can disengage the PLL without turning it off.
Applications that require the PLL to wake the MCU from WAIT mode
also can deselect the PLL output without turning off the PLL.
Technical Data
142
MC68HC08AB16A — Rev. 2.0
Clock Generator Module (CGM)
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA