PIC18F87J10 Datasheet, PDF (39/394 Pages) Microchip Technology – 64/80-Pin High-Performance, 1-Mbit Flash Microcontrollers with nanoWatt Technology

PIC18F87J10 FAMILY
Note:
The Timer1 oscillator should already be
running prior to entering SEC_RUN mode.
If the T1OSCEN bit is not set when the
SCS1:SCS0 bits are set to ‘01’, entry to
SEC_RUN mode will not occur. If the
Timer1 oscillator is enabled, but not yet
running, device clocks will be delayed until
the oscillator has started. In such situa-
tions, initial oscillator operation is far from
stable and unpredictable operation may
result.
On transitions from SEC_RUN mode to PRI_RUN, the
peripherals and CPU continue to be clocked from the
Timer1 oscillator while the primary clock is started.
When the primary clock becomes ready, a clock switch
back to the primary clock occurs (see Figure 3-2).
When the clock switch is complete, the T1RUN bit is
cleared, the OSTS bit is set and the primary clock is
providing the clock. The IDLEN and SCS bits are not
affected by the wake-up; the Timer1 oscillator
continues to run.
FIGURE 3-1:
TRANSITION TIMING FOR ENTRY TO SEC_RUN MODE
Q1 Q2 Q3 Q4 Q1
T1OSI
1
OSC1
CPU
Clock
Peripheral
Clock
Program
Counter
PC
2
3
n-1 n
Clock Transition
PC + 2
Q2 Q3 Q4 Q1 Q2 Q3
PC + 4
FIGURE 3-2:
TRANSITION TIMING FROM SEC_RUN MODE TO PRI_RUN MODE (HSPLL)
Q1
Q2
Q3
Q4 Q1
Q2 Q3 Q4 Q1 Q2 Q3
T1OSI
OSC1
PLL Clock
Output
CPU Clock
TOST⁽¹⁾
TPLL⁽¹⁾
1 2 n-1 n
Clock
Transition
Peripheral
Clock
Program
Counter
PC
PC + 2
SCS1:SCS0 bits Changed
OSTS bit Set
Note 1: TOST = 1024 TOSC; TPLL = 2 ms (approx). These intervals are not shown to scale.
PC + 4
 2005 Microchip Technology Inc.
Advance Information
DS39663A-page 37