PIC18F87J10 Datasheet, PDF (341/394 Pages) Microchip Technology – 64/80-Pin High-Performance, 1-Mbit Flash Microcontrollers with nanoWatt Technology

PIC18F87J10 FAMILY
26.2 DC Characteristics: Power-Down and Supply Current
PIC18F87J10 Family (Industrial) (Continued)
PIC18F87J10 Family
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
Param
No.
Device
Typ Max Units
Conditions
Supply Current (IDD)^(2,3)
All devices TBD TBD µA
-40°C
TBD TBD µA
TBD TBD µA
All devices TBD TBD µA
TBD TBD µA
TBD TBD µA
+25°C
+85°C
-40°C
+25°C
+85°C
VDD = 2.0V
VDD = 2.5V
FOSC = 31 kHz
(RC_RUN mode,
Internal oscillator source)
All devices TBD TBD µA
-40°C
TBD TBD µA
+25°C
VDD = 3.3V
TBD TBD µA
+85°C
All devices TBD TBD µA
-40°C
TBD TBD µA
TBD TBD µA
All devices TBD TBD µA
TBD TBD µA
TBD TBD µA
+25°C
+85°C
-40°C
+25°C
+85°C
VDD = 2.0V
VDD = 2.5V
FOSC = 31 kHz
(RC_IDLE mode,
Internal oscillator source)
All devices TBD TBD µA
-40°C
TBD TBD µA
+25°C
VDD = 3.3V
TBD TBD µA
+85°C
Legend:
Note 1:
2:
3:
4:
TBD = To Be Determined
The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD or VSS and all features that add delta
current disabled (such as WDT, Timer1 oscillator, BOR, etc.).
The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR = VDD; WDT enabled/disabled as specified.
For RC oscillator configurations, current through REXT is not included. The current through the resistor can be estimated
by the formula Ir = VDD/2REXT (mA) with REXT in kΩ.
Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
 2005 Microchip Technology Inc.
Advance Information
DS39663A-page 339