PIC18F87J10 Datasheet, PDF (337/394 Pages) Microchip Technology – 64/80-Pin High-Performance, 1-Mbit Flash Microcontrollers with nanoWatt Technology

PIC18F87J10 FAMILY
26.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings^(†)
Ambient temperature under bias.............................................................................................................-40°C to +125°C
Storage temperature .............................................................................................................................. -65°C to +150°C
Voltage on any digital-only I/O pin with respect to VSS (except VDD and MCLR) ........................................ -0.3V to 5.5V
Voltage on any combined digital and analog pin with respect to VSS (except VDD and MCLR)...... -0.3V to (VDD + 0.3V)
Voltage on VDDCORE with respect to VSS................................................................................................... -0.3V to 2.75V
Voltage on VDD with respect to VSS ........................................................................................................... -0.3V to 3.6V
Voltage on MCLR with respect to VSS (Note 2) ............................................................................................... 0V to 3.6V
Total power dissipation (Note 1) ...............................................................................................................................1.0W
Maximum current out of VSS pin ...........................................................................................................................300 mA
Maximum current into VDD pin ..............................................................................................................................250 mA
Input clamp current, IIK (VI < 0 or VI > VDD)...................................................................................................................... ±20 mA
Output clamp current, IOK (VO < 0 or VO > VDD) .............................................................................................................. ±20 mA
Maximum output current sunk by PORTB and PORTC I/O pins.............................................................................25 mA
Maximum output current sunk by PORTD, PORTE and PORTJ I/O pins .................................................................8 mA
Maximum output current sunk by PORTA, PORTF, PORTG and PORTH I/O pins ..................................................2 mA
Maximum output current sourced by PORTB and PORTC I/O pins .......................................................................25 mA
Maximum output current sourced by PORTD, PORTE and PORTJ I/O pins............................................................8 mA
Maximum output current sourced by PORTA, PORTF, PORTG and PORTH I/O pins .............................................2 mA
Maximum current sunk by all ports .......................................................................................................................200 mA
Maximum current sourced by all ports ..................................................................................................................200 mA
Note 1: Power dissipation is calculated as follows:
Pdis = VDD x {IDD – ∑ IOH} + ∑ {(VDD – VOH) x IOH} + ∑(VOL x IOL)
2: Voltage spikes below VSS at the MCLR pin, inducing currents greater than 80 mA, may cause latch-up.
Thus, a series resistor of 50-100Ω should be used when applying a “low” level to the MCLR pin, rather than
pulling this pin directly to VSS.
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions above those
indicated in the operation listings of this specification is not implied. Exposure to maximum rating conditions for
extended periods may affect device reliability.
 2005 Microchip Technology Inc.
Advance Information
DS39663A-page 335