SE7210TP1-E Datasheet, PDF (72/145 Pages) Intel Corporation – Intel® Server Board Technical Product Specification

Intel® Server Board SE7210TP1-E TPS
System BIOS
The submenu represented by Table 29 is used to configure the USB features.
Table 29. USB Configuration Submenu
Feature
USB Devices Enabled
USB Function
Legacy USB Support
Port 64/60 Emulation
USB 2.0 Controller
USB 2.0 Controller
mode
USB Beep Message
USB Mass Storage
Device Configuration
Options
• NO option
• Disable
• 2 USB Ports
• All USB Ports (default)
• Enable (default)
• Disable
• Auto
• Enable
• Disable (default)
• Enable (default)
• Disable
• FullSpeed
• HiSpeed (default)
• Enable (default)
• Disable
• Submenu
Description
USB device numbers.
Enable USB HOST control.
Support legacy USB.
This option is typically not used since most OSes are
now USB-aware.
Support USB2.0.
Configures the USB 2.0 controller in HiSpeed
(480Mbps) or FullSpeed (12Mbps).
When USB 2.0 Controller is disabled, it will disappear
Enables the beep during USB device enumeration.
Configure the USB Mass Storage Device Class.
Only available when USB Mass Storage Device detected in
system.
4.8.4.7.1
BIOS Setup USB Mass Storage Device Configuration Sub-menu Selections
Table 30. USB Mass Storage Device Configuration Sub-menu Selections
Feature
USB Mass Storage
Reset Delay
Device #1
Emulation Type
Options
10 Sec
20 Sec
30 Sec
40 Sec
N/A
Auto
Floppy
Forced
FDD
Hard Disk
CDROM
Help Text
Number of seconds POST waits for the USB mass
storage device after start unit command.
N/A
If Auto is selected, USB devices less than 530MB will be
emulated as Floppy drives and the remaining as hard
drives. The Forced FDD option will force a formatted
HDD to boot as a FDD (Ex. ZIP drive).
Description
Only displayed if a
device is detected,
includes a
DeviceID string
returned by the
USB device.
58
Revision 2.0