SE7210TP1-E Datasheet, PDF (134/145 Pages) Intel Corporation – Intel® Server Board Technical Product Specification

Intel® Server Board SE7210TP1-E TPS
Connector Pin-Outs and Jumper Blocks
7.12 Miscellaneous Headers
7.12.1
Fan Headers
The Intel Server Board SE7210TP1-E provides seven 3-pin fan headers. All fans use direct 12
volts. The six system fans and one processor fan are wired to the input of the Hardware
Management (ADM1027 or ADT7463/SIO) and are monitored by Intel Server Management.
Pin
Signal Name
1 GND
2 FAN_FRONT1_PWR
FAN_FRONT2_PWR
FAN_REAR_PWR
3 Fan Tach
Table 83. Three-Pin Fan Headers Pin-Out
Type
Description
Power GROUND is the power supply ground
Power 12 V
Out FAN_TACH signal is connected to the Hardware Management
(ADM1027or ADT7463/ SIO) to monitor the fan speed
7.13 System Recovery and Update Jumper
CAUTION
Do not move any jumpers with the power on. Always turn off the power and unplug the power cord
from the server before changing a jumper setting. Otherwise, the board could be damaged.
This 3-pin jumper block determines the BIOS Setup program mode. Table 84 describes the
jumper settings for the two modes: normal and recovery.
Function/Mode
Normal Boot
Table 84. BIOS Setup Configuration Jumper Settings (J1D1)
Jumper Setting
Configuration
3
13-14
The BIOS uses current configuration information and passwords for
booting.
1
Recovery
3
14-15
1
The BIOS attempts to recover the BIOS configuration. A recovery
diskette is required.
120
Revision 2.0