SE7210TP1-E Datasheet, PDF (49/145 Pages) Intel Corporation – Intel® Server Board Technical Product Specification

Intel® Server Board SE7210TP1-E TPS
Functional Architecture
Right
Green
Orange
On (steady state)
On (brighter and pulsing)
Off
On
On
LAN link is established.
The server is communicating with another
computer on the LAN.
10 Mbit/sec data rate is selected.
100 Mbit/sec data rate is selected.
1000 Mbit/sec data rate is selected.
3.4.10
USB 2.0 Support
The USB controller functionality integrated into 6300ESB I/O provides the baseboard with the
interface for up to four USB 2.0 ports. Three external connectors are located on the back edge
of the baseboard. One internal 2x5 header is provided, capable of supporting an additional
optional connector.
3.4.11
I/O Controller
The Winbond* W83627HF-AW I/O Controller provides the following features:
• Two serial ports
• Serial IRQ interface compatible with serialized IRQ support for PCI systems
• PS/2-style mouse and keyboard interfaces
• Interface for one 1.44 MB diskette drive
• Intelligent power management, including a programmable wake-up event interface
• PCI power management support
The BIOS Setup program provides configuration options for the I/O controller.
For information about
WINBOND W83627HF-AW I/O controller
Refer to
http://www.Winbond.com
3.4.11.1
Serial Ports
The Intel Server Board SE7210TP1-E has one 9-pin D-sub serial port connector and one 2 x 5
serial port header. The serial port A connector is located in the rear I/O area. The serial port B
header is located near serial port A. Two high-speed 16550 compatible UARTs with 16-byte
send/receive FIFOs.
For information about
The signal names of the serial port A connector
The location of the serial port B header
The signal names of the serial port B header
Refer to
Table 80
Figure 1
Table 81
3.4.11.2
Floppy Disk Controller
The floppy disk controller of the W83627HF-AW integrates all of the logic required for floppy
disk control. The FDC implements a PC/AT or PS/2 solution.
Revision 2.0
35