SE7210TP1-E Datasheet, PDF (67/145 Pages) Intel Corporation – Intel® Server Board Technical Product Specification

Intel® Server Board SE7210TP1-E TPS
System BIOS
Feature
IDE Detect Time Out
(Sec)
ATA (PI) 80Pin Cable
Detection
Options
•0
•5
• 10
• 15
• 20
• 25
• 30
• 35(default)
• Host & Device (default)
• Host
• Device
Description
Select time out value for ATA/ATAPI.
Select the mechanism for detecting 80pin ATA.
4.8.4.4.1
Map PATA to Legacy ATA, Config SATA Sub-menu Selections
To access this menu, select Advanced on the menu bar, then IDE Configuration.
Main
Advanced
Boot
Security
Server
Exit
>CPU Configuration
>IDE Configuration
>Floppy Configuration
>Super I/O Configuration
>USB Configuration
>PCI Configuration
The submenu represented by Table 22 is used to configure the IDE Configuration.
Table 22. Primary/Secondary/Third/Fourth Master/Slave Submenu
Feature
SATA Control
Enhanced
Options
• Enabled (default)
• Disabled
P-ATA Channel
Selection
• Primary
• Secondary
• Both (default)
S-ATA Ports Definition • A1-3rd, A2-4th. (default)
• A1-4th, A2-3rd.
Description
If enabled, PATA ports may use the primary
and/or secondary ATA channel addresses and the
SATA ports are limited to using the third and
fourth ATA channel addresses. If disabled, the
SATA ports are not available.
Selection determines assignment of only primary,
only secondary or both ATA channel addresses
for the PATA ports.
This option allows swapping of port mappings
between the third and fourth ATA channels for the
SATA ports.
4.8.4.4.2
Map SATA to Legacy ATA, Disable PATA Sub-menu Selections
To access this menu, select Advanced on the menu bar, then IDE Configuration.
Revision 2.0
53