SE7210TP1-E Datasheet, PDF (133/145 Pages) Intel Corporation – Intel® Server Board Technical Product Specification

Intel® Server Board SE7210TP1-E TPS
Connector Pin-Outs and Jumper Blocks
Table 81. 10-pin Header Serial B Port Pin Out (J8A2)
Pin
Signal Name
1 DCD (Data Carrier Detect)
2 DSR (Data Set Ready)
3 RXD (Receive Data)
4 RTS (Request to Send)
5 TXD (Transmit Data)
6 CTS (Clear to Send)
7 DTR (Data Terminal Ready)
8 RI (Ring indicator)
9 GND
10 Key
7.11 Keyboard and Mouse Connector
PS/2 keyboard and mouse connectors are located on the back panel. The +5 V lines to these
connectors are protected with a PolySwitch* circuit that, like a self-healing fuse, reestablishes
the connection after an overcurrent condition is removed.
✏ ^NOTE
The keyboard is supported in the bottom PS/2 connector and the mouse is supported in the top
PS/2 connector. Power to the server should be turned off before a keyboard or mouse is
connected or disconnected.
The keyboard controller contains the AMI keyboard and mouse controller code, provides the
keyboard and mouse control functions, and supports password protection for power-on/reset. A
power-on/reset password can be specified in the BIOS Setup program.
Table 82. Keyboard /Mouse PS/2 Connector Pin Out (J9A1)
Connector Pin Signal Name
Keyboard 1 Data
2 NC
3 GND
4 +5 V (Fused)
5 Clock
6 NC
Mouse
7 Data
8 NC
9 GND
10 +5 V (Fused)
11 Clock
12 NC
13 NC
14 NC
15 NC
16 NC
17 NC
Revision 2.0
119