|
SE7210TP1-E Datasheet, PDF (47/145 Pages) Intel Corporation – Intel® Server Board Technical Product Specification | |||
|
◁ |
Intel® Server Board SE7210TP1-E TPS
Functional Architecture
Intel Server Board SE7210TP1-E supports independent disabling of the two NIC controllers
using the BIOS Setup menu.
The NIC subsystem consists of the following:
⢠Intel 82547GI Platform LAN Connect (PLC) device for 10/100/1000 Mbits/sec Ethernet
LAN connectivity
⢠Intel 82551QM device for 10/100 Mbits/sec Ethernet LAN connectivity
⢠RJ-45 LAN connector with integrated status LEDs
The 82547GI is controlled by the CSA interface off of the MCH and supports the following
features:
⢠Basic 10/100/1000 Ethernet LAN connectivity
⢠Integrated Gigabit Ethernet Media Access Control (MAC) and physical layer (PHY)
⢠IEEE 802.3 10BASE-T/100BASE-TX/1000BASE-T compliant physical layer interface
⢠IEEE 802.3ab Auto-Negotiation support
⢠Low power (less than 350mW in active transmit mode)
⢠Reduced power in âunplugged modeâ (less than 50mW)
⢠Automatic detection of âunplugged modeâ
⢠Communication Streaming Architecture (CSA) port provides higher throughput and lower
latencies resulting in up to 30% higher bus throughput (up to wire speed)
⢠Full device driver compatibility
⢠Programmable transit threshold
⢠Configuration EEPROM that contains the MAC address
⢠Teaming and Fail over support
The 82551QM is controlled by the 6300ESB I/O and supports the following features:
⢠Integrated IEEE 802.3 10BASE-T and 100BASE-TX compatible PHY
⢠32-bit PCI/CardBus master interface
⢠Modem interface for combination solutions
⢠Integrated power management functions
⢠Full Duplex support at both 10 and 100 Mbps
⢠IEEE 802.3u Auto-Negotiation support
⢠3 Kbyte transmit and 3 Kbyte receive FIFOs
⢠Fast back-to-back transmission support with minimum interframe spacing
⢠IEEE 802.3x 100BASE-TX Flow Control support
⢠Advanced Power management capabilities
⢠Low power 3.3 V device
⢠Efficient dynamic standby mode
⢠Deep power down support
⢠Clockrun protocol support
Revision 2.0
33
|
▷ |