SE7210TP1-E Datasheet, PDF (22/145 Pages) Intel Corporation – Intel® Server Board Technical Product Specification

Intel® Server Board SE7210TP1-E TPS
Functional Architecture
3.1.1
Reset Configuration Logic
The BIOS determines the processor stepping, cache size, and other processor information
through the CPUID instruction. The requirement is for the processor to run at a fixed speed. The
processor cannot be programmed to operate at a lower or higher speed.
On the SE7210TP1-E platform, the BIOS is responsible for configuring the processor speed.
The BIOS uses CMOS settings to determine which speed to program into the speed setting
device. The processor information is read at every system power-on.
3.1.2
Processor Support
The Intel Server Board SE7210TP1-E supports a single Intel^® Pentium^® 4 processor, or a single
Intel^® Celeron^® processor with a system bus of 400 /533 /800 MHz. The server board supports
the processors listed in Table 1.
Table 1. Processor Support Matrix
Type
Pentium® 4 processor supporting Hyper-Threading
Technology
Pentium® 4 processor supporting Hyper-Threading
Technology
Pentium® 4 processor supporting Hyper-Threading
Technology
Pentium® 4 processor supporting Hyper-Threading
Technology
Pentium® 4 processor supporting Hyper-Threading
Technology
Pentium® 4 processor
Celeron® processor
Designation
3.4, 3.2 GHz
System Bus L2 Cache Size
800 MHz
2 MB
3.4, 3.2, 3.0, 2.8
GHz
2.8 GHz
800 MHz
533 MHz
1 MB
1 MB
3.2, 3.0, 2.80, 2.40,
2.60 GHz
3.06 GHz
800 MHz
533 MHz
512 KB
512 KB
2.8, 2.66, 2.6, 2.53,
2.4, 2.26, 2.0 GHz
2.8, 2.7, 2.6, 2.5,
2.4, 2.3, 2.2, 2.1,
2.0 GHz
400 / 533 MHz
400 MHz
512 KB
128 KB
CAUTION
Use only the processors listed above. Use of unsupported processors can damage the board,
the processor, and the power supply. See the Intel^® Server Board SE7210TP1-E Specification
Update or go to http://support.intel.com/support/motherboards/server/SE7210TP1-E/ for the
current list of supported processors for this board.
✏ ^NOTE
Use only ATX12V or EPS12V compliant power supplies with the server board SE7210TP1-E.
ATX12V and EPS12V power supplies have an additional power lead that provides required
supplemental power for the Intel Pentium 4 processor. The board will not boot if you do not
connect the 20-pin (or 24-pin) and 4-pin (or 8-pin) leads of ATX12V or EPS12V power supplies
to the corresponding connectors.
Do not use a standard ATX power supply. The board will not boot with a standard ATX power
supply.
8
Revision 2.0