SE7210TP1-E Datasheet, PDF (30/145 Pages) Intel Corporation – Intel® Server Board Technical Product Specification

Intel® Server Board SE7210TP1-E TPS
Functional Architecture
Table 2. Supported Memory Configurations
DIMM Capacity Configuration DDR SDRAM
Density
128 MB
DS
64 Mbit
DDR SDRAM Organization
Front-side/Back-side
8 M x 8/8 M x 8
Number of DDR
SDRAM Devices
16
128 MB
SS
128 Mbit
16 M x 8/empty
8
128 MB
SS
256 Mbit
16 M x 16/empty
4
256 MB
DS
128 Mbit
16 M x 8/16 M x 8
16
256 MB
SS
256 Mbit
32 M x 8/empty
8
256 MB
SS
512 Mbit
32 M x 16/empty
4
512 MB
DS
256 Mbit
32 M x 8/32 M x 8
16
512 MB
SS
512 Mbit
64 M x 8/empty
8
1024 MB
DS
512 Mbit
64 M x 8/64 M x 8
16
Note: In the second column, “DS” refers to double-sided memory modules (containing two rows of DDR
SDRAM) and “SS” refers to single-sided memory modules (containing one row of DDR SDRAM).
DIMM and memory configurations must adhere to the following:
• 2.5 V (only) 184-pin DDR SDRAM DIMMs with gold-plated contacts
• Unbuffered, single-sided or double-sided DIMMs with the following restriction:
• Double-sided DIMMS with x16 organization are not supported.
• Maximum total system memory: 4 GB
• Minimum total system memory: 128 MB
• ECC and non-ECC DIMMs supported
• Serial Presence Detect
• PC3200 (400 MHZ), PC2700 (333 MHZ), and PC2100 (266 MHZ) SDRAM DIMMs
Table 3 lists the supported system bus frequency and memory speed combinations.
Table 3. Supported System Bus Frequency and Memory Speed Combinations
To use this type of DIMM…
PC3200 (400 MHZ)
PC2700 (333 MHZ)
PC2100 (266 MHZ)
The processor's system bus frequency must be…
800 MHz
800 or 533 MHz (Note)
800, 533, or 400 MHz
Note: When using PC2700 (333 MHZ) memory with an 800 MHz system bus frequency processor, the memory
channel will be set to 320 MHz.
Only DIMMs tested and qualified by Intel or a designated memory test vendor will be supported
on the Intel Server Board SE7210TP1-E. A list of qualified DIMMs will be made available
through http://support.intel.com/support/motherboards/server/SE7210TP1-E/. Note that all
DIMMs are supported by design, but only fully qualified DIMMs will be supported.
16
Revision 2.0