MB86613S Datasheet, PDF (83/134 Pages) Fujitsu Component Limited. – IEEE1394 Open HCI Controller

Preliminary
OUTPUT_LAST_Immediate command of context program processed by AT- CPC is set.
8) asynchronous stream packet :
It can transmit an asynchronous stream packet that has the same format as an isochronous packet
during fairness cycle. The packet is transmitted by AT- CPC.
9) acknowledge :
ack_tardy will be newly supported.
It reports ack_tardy as acknowledge if a packet is received when the system power is OFF.
After that it asserts the PME#.
ack_conflict_error and ack_address_error are not supported.
10) port disable :
For disabling to provide a power to TpBias, set the Disabled bit of PHY register after selecting the port
number to be disabled with Port_select field to set ”000b” in Page_select field of PHY register.
If ”1h” (transmit TX_DISABLE_NOTIFY then disable port) is set at cmnd field of this packet when
receiving remote command packet, providing TpBias to the port set in port field will be stopped.
If ”5h” (enable port) is set at cmnd field of this packet, providing TpBias to the port set in port field will be
started.
TpBias will not be provided if resume is done when Disable bit of PHY register is cleared.
11) priority budget register :
LINK layer executes the priority request as the number specified in ’pri_req’ field of FairnessControl
register described in Section 3.20.
Software must support the priority budget register.
12) remote access/reply packet :
The contents of PHY register in other node can be known by transmitting remote access packet.
When receiving remote access packet, remote reply packet is transmitted automatically, which
contains information for PHY register set in remote access packet.
13) remote command/confirmation packet :
Transmission of remote command packet executes the command set in cmnd field of this packet for
other node.
When remote command packet is received, remote confirmation packet is transmitted after executing
the command which is set in cmnd field for the port set in port field of remote command packet.
14) resume packet :
Transmission of resume packet starts resume for each port.
When receiving resume packet, resume for each port starts.
15) suspend/resume :
If ”2h” (initiate suspend) is set at cmnd field of this packet when receiving remote command packet,
port connection set in port field will be suspended.
If ”6h” (resume port) is set at cmnd field of this packet when receiving remote command packet, port
connection set in port field will be resumed.
82