MB86613S Datasheet, PDF (29/134 Pages) Fujitsu Component Limited. – IEEE1394 Open HCI Controller

Preliminary
3.2.3. ATRetries
This register sets the retry count when transmitting the asynchronous packet or receiving the “ack_busy_#” or
“ack_data_error” acknowledge. The register performs the retries of the count set here when the received
acknowledge is “ack_busy_#” or “ack_data_error”. “0” are indicated on the secondLimit and the cycleLimit
fields respectively because the MB86613S does not support the dual phase relay.
31
24 23
16 15
cycleLimit
87
0
secondLimit
maxATReqRetries
maxATRespRetries
maxPhyRespRetries
Bit
Field Name
rwu
---- -------------- ----
31:29 secondLimit
r
28:16 cycleLimit
r
reset
--------
0h
000h
description
------------------------------------------
The device supports only single phase retry function. So,
these bits indicate ”0”.
11:8 maxPhyResp
Retries
7:4 maxATResp
Retries
3:0 maxATReq
Retries
rw
undefined Set the retry count for the transmit phy response packet.
rw
undefined Set the retry count for the transmit asynchronous response
packet.
rw
undefined Set the retry count for the transmit asynchronous request
packet.
3.2.4. Bus Management CSR
This register is used for making the device operate the automatic compare- swap for the on- chip bus manage-
ment CSR while the MB86613S device is operating as the resource manager. This register is used as follows:
Store the data that you want to set in the bus management CSR in the csrData. Then, store the data to be
compared with the bus management CSR in the csrCompare. After that, select any of register for the bus
management CSR by csrSel bit. At that time, the csrDone bit is cleared.
With these steps, if the compare- swap is completed, ”1” is indicated in the csrDone bit. At that time, the csrDa-
ta indicate the data previously stored in the bus management CSR which has been selected by the csrSel bit.
This means, if the compare- swap is succeeded, the same data are read out from the csrData and csrCom-
pare. In case the different data are read out from these bits, please set the data read out from the csrData in
the csrCompare and repeat the same steps as above.
Bus reset loads ’3Fh’ to bus_manager_ID register and the following registers value to other three Bus man-
agement CSR registers.
CSR Address
-------------------
”FFFF_F000_021Ch”
”FFFF_F000_0220h”
”FFFF_F000_0224h”
”FFFF_F000_0228h”
csrSel
-----
’00b’
’01b’
’10b’
’11b’
by Bus reset
---------
3Fh
InitialBandwidthAvailable
InitialChannelsAvailableHi
InitialChannelsAbailableLo
description
------------------
bus_manager_ID
bandwidth_available
channels_available_hi
channels_available_lo
28