MB86613S Datasheet, PDF (8/134 Pages) Fujitsu Component Limited. – IEEE1394 Open HCI Controller

2.3.2. Memory Interface
Name of pin
EEDI
EEDO
I/O
Function
O
Data output pin for EEPROM device.
I
Data input pin for EEPROM device.
Preliminary
EECS
EECLK
O
Chip Select pin to select the externally connected EEPROM device.
O
Clock output pin for EEPROM device.
2.3.3. 1394 Interface
Name of pin
TPA
TPB
TPA#
TPB#
TPBIAS
CPS
RO
I/O
Function
I/O
TPA positive signals of 1394 cable port.
I/O
TPB positive signals of 1394 cable port.
I/O
TPA negative signals of 1394 cable port.
I/O
TPB negative signal of 1394 cable port.
O
TP Bias voltage supply pin.
I
Cable Power input pin.
O
Load resistance connection pin (Connect with GND via a 5.1kW. resistor)
2.3.4. Others
Name of pin
I/O
Function
X1(CLK), X0
I
Clock input pin for the on- chip PLL (24.576MHz) or Crystal oscillator pins
RF
O
Connect this pin with GND via a 5.1kW. resistor)
FIL
O
Filter circuit connection pin.
TEST
N.C.
I
This pin is used for the test mode. Normally connect this pin with GND.
-
Non- connection pins. Do not connect with these pins.
7