MC68HC908RK2 Datasheet, PDF (80/158 Pages) Motorola, Inc – Microcontroller Unit

Internal Clock Generator Module (ICG)
CMF — Clock Monitor Interrupt Flag
This read-only bit is set when the clock monitor determines that either ICLK or ECLK becomes inactive
and the CMON bit is set. This bit is cleared by first reading the bit while it is set, followed by writing the
bit low. This bit is forced clear when CMON is clear or during reset.
1 = Either ICLK or ECLK has become inactive.
0 = ICLK and ECLK have not become inactive since the last read of the ICGCR or the clock monitor
is disabled.
CMON — Clock Monitor On Bit
This read/write bit enables the clock monitor. CMON can be set when both ICLK and ECLK have been
on and stable for at least one bus cycle (ICGON, ECGON, ICGS, and ECGS are all set). CMON is
forced set when CMF is set, to avoid inadvertent clearing of CMF. CMON is forced clear when either
ICGON or ECGON is clear or during reset.
1 = Clock monitor output enabled
0 = Clock monitor output disabled
CS — Clock Select Bit
This read/write bit determines which clock will generate the oscillator output clock (CGMXCLK). This
bit can be set when ECGON and ECGS have been set for at least one bus cycle and can be cleared
when ICGON and ICGS have been set for at least one bus cycle. This bit is forced set when the clock
monitor determines the internal clock (ICLK) is inactive or when ICGON is clear. This bit is forced clear
when the clock monitor determines that the external clock (ECLK) is inactive, when ECGON is clear,
or during reset.
1 = External clock (ECLK) sources CGMXCLK
0 = Internal clock (ICLK) sources CGMXCLK
ICGON — Internal Clock Generator On Bit
This read/write bit enables the internal clock generator. ICGON can be cleared when the CS bit has
been set and the CMON bit has been clear for at least one bus cycle. ICGON is forced set when the
CMON bit is set, the CS bit is clear, or during reset.
1 = Internal clock generator enabled
0 = Internal clock generator disabled
ICGS — Internal Clock Generator Stable Bit
This read-only bit indicates when the internal clock generator has determined that the internal clock
(ICLK) is within about 5% of the desired value. This bit is forced clear when the clock monitor
determines the ICLK is inactive, when ICGON is clear, when the ICG multiplier factor is written, or
during reset.
1 = Internal clock is within 5% of the desired value.
0 = Internal clock may not be within 5% of the desired value.
ECGON — External Clock Generator On Bit
This read/write bit enables the external clock generator. ECGON can be cleared when the CS and
CMON bits have been clear for at least one bus cycle. ECGON is forced set when the CMON bit or the
CS bit is set. ECGON is forced clear during reset.
1 = External clock generator enabled
0 = External clock generator disabled
MC68HC908RK2 Data Sheet, Rev. 5.1
80
Freescale Semiconductor