MC68HC908GZ8 Datasheet, PDF (211/344 Pages) Motorola, Inc – Microcontrollers

Input/Output (I/O) Ports
Port D
MISO — Master In/Slave Out
The PTD1/MISO pin is the master in/slave out terminal of the SPI module. When
the SPI enable bit, SPE, is clear, the SPI module is disabled, and the PTD0/SS
pin is available for general-purpose I/O.
Data direction register D (DDRD) does not affect the data direction of port D pins
that are being used by the SPI module. However, the DDRD bits always
determine whether reading port D returns the states of the latches or the states
of the pins. See Table 17-5.
SS — Slave Select
The PTD0/SS pin is the slave select input of the SPI module. When the SPE bit
is clear, or when the SPI master bit, SPMSTR, is set, the PTD0/SS pin is
available for general-purpose I/O. When the SPI is enabled, the DDRB0 bit in
data direction register B (DDRB) has no effect on the PTD0/SS pin.
17.5.2 Data Direction Register D
Data direction register D (DDRD) determines whether each port D pin is an input
or an output. Writing a logic 1 to a DDRD bit enables the output buffer for the
corresponding port D pin; a logic 0 disables the output buffer.
Address:
Read:
Write:
Reset:
$0007
Bit 7
DDRD7
0
6
DDRD6
0
5
DDRD5
0
4
DDRD4
0
3
DDRD3
0
2
DDRD2
0
1
DDRD1
0
Figure 17-14. Data Direction Register D (DDRD)
Bit 0
DDRD0
0
NOTE:
DDRD7–DDRD0 — Data Direction Register D Bits
These read/write bits control port D data direction. Reset clears
DDRD7–DDRD0, configuring all port D pins as inputs.
1 = Corresponding port D pin configured as output
0 = Corresponding port D pin configured as input
Avoid glitches on port D pins by writing to the port D data register before changing
data direction register D bits from 0 to 1.
Figure 17-15 shows the port D I/O logic.
MC68HC908GZ8
Freescale Semiconductor
Input/Output (I/O) Ports
Data Sheet
211