W83C553F Datasheet, PDF (9/159 Pages) Winbond – SYSTEM I/O CONTROLLER WITH PCI ARBITER

W83C553F
General Information
Power Management Break Event support for Green PC applications
Built-in Integrated Peripheral Controller (IPC) with standard PC-AT peripherals
•
Two 82C37A DMA controllers (types A, B, and F)
- 32-bit addressing allows use of alternate CPUs, such as PowerPC
- supports multiple 8-bit and 16-bit scatter/gather DMA channels
•
Two 82C59A interrupt controllers
- all IRQ inputs may be programmed for edge or level sensitivity
•
One 82C54 counter/timer
•
Routes external PCI interrupts to a software-selectable interrupt channel
PCI Bus Interface
•
PCI Revision 2.1 compliant
•
PCI clock frequencies up to 33 MHz at 5V
•
Supports delayed completion for ISA cycles
•
Active address decoding for internal I/O devices
•
Subtractive decoding for ISA bridge, KBC and RTC
•
Supports disconnection (with retry) for slow internal accesses to improve latency
•
Short PCI bus ownership when mastering to minimize overall system latency
•
Fast DMA transfers from I/O devices to PCI agents as a master
•
Separate request and grant signals for ISA DMA and IDE controllers
ISA Bus Bridge
•
•
Full implementation of a standard ISA bus
•
Separate ISA and IDE data buses reduce noise and increase system performance
•
Synchronous PCI-to-ISA interface with direct drive for 5 ISA slots
XD-Bus interface
•
Support for BIOS ROM or PowerPC systems boot ROM
•
Support for flash EPROM
•
Provides keyboard controller connections
•
Provides real-time clock connections
•
Provides data buffer control
Miscellaneous
•
Port B support
•
Port 92 support
Uses 0.6um, ultra-low power CMOS technology for Rev. E and below; 0.5um for Rev. G.
Packaged in a 208-pin PQFP package
WINBOND SYSTEMS LABORATORY
6