MC68HC908AZ60 Datasheet, PDF (439/480 Pages) Motorola, Inc – HCMOS Microcontroller Unit

Specifications
Electrical Specifications
NOTES:
1. V_DD = 5.0 Vdc ± 10%, V_SS = 0 Vdc, T_A = –40 °C to +T_A(MAX), unless otherwise noted.
2. Run (Operating) I_DD measured using external square wave clock source (f_BUS = 8.4 MHz). All inputs
0.2 V from rail. No dc loads. Less than 100 pF on all outputs. C_L = 20 pF on OSC2. All ports
configured as inputs. OSC2 capacitance linearly affects run I_DD. Measured with all modules enabled.
3. Wait I_DD measured using external square wave clock source (f_BUS = 8.4 MHz). All inputs 0.2 Vdc
from rail. No dc loads. Less than 100 pF on all outputs, C_L = 20 pF on OSC2. All ports configured
as inputs. OSC2 capacitance linearly affects wait I_DD. Measured with all modules enabled.
4. Stop I_DD measured with OSC1 = V_SS.
5. Maximum is highest voltage that POR is guaranteed.
6. Maximum is highest voltage that POR is possible.
7. If minimum V_DD is not reached before the internal POR reset is released, RST must be driven low
externally until minimum V_DD is reached.
8. See COP Module During Break Interrupts on page 184.
9. Although I_DD is proportional to bus frequency, a current of several mA is present even at very low
frequencies.
10. See Monitor Mode description within COP section. V_HI applied to IRQ or RST.
5-specs
MOTOROLA
Specifications
MC68HC908AZ60 — Rev 2.0
437