COP8AME9_14 Datasheet, PDF (8/102 Pages) Texas Instruments – COP8AME9 8-Bit CMOS Flash Microcontroller with 8k Memory, Dual Op Amps, Virtual EEPROM, Temperature Sensor, 10-Bit A/D and Brownout Reset

COP8AME9, COP8ANE9
SNOS930F – MARCH 2001 – REVISED MARCH 2013
www.ti.com
AC Electrical Characteristics (−40°C ≤ T_A ≤ +85°C)
Datasheet min/max specification limits are ensured by design, test, or statistical analysis.
Parameter
Conditions
Min
Typ
Instruction Cycle Time (t_C)
Crystal/Resonator
4.5V ≤ V_CC ≤ 5.5V
0.5
Frequency of MICROWIRE/PLUS in Slave Mode
MICROWIRE/PLUS Setup Time (t_UWS)
20
MICROWIRE/PLUS Hold Time (t_UWH)
20
MICROWIRE/PLUS Output Propagation Delay (t_UPD)
Input Pulse Width
Interrupt Input High Time
1
Interrupt Input Low Time
1
Timer 1 Input High Time
1
Timer 1 Input Low Time
1
Timer 2, 3 Input High Time ⁽¹⁾
1
Timer 2, 3 Input Low Time ⁽¹⁾
1
Output Pulse Width
Timer 2, 3 Output High Time
150
Timer 2, 3 Output Low Time
150
USART Bit Time when using External CKX
6 CKI
periods
USART CKX Frequency when being Driven by Internal
Baud Rate Generator
Reset Pulse Width
0.5
Flash Memory Mass Erase Time
8
Flash Memory Page Erase Time
See Table 15, Typical Flash
Memory Endurance
1
Max
Units
DC
μs
2
MHz
ns
ns
150
ns
t_C
t_C
t_C
t_C
MCLK or t_C
MCLK or t_C
ns
ns
2
MHz
μs
ms
ms
(1) If timer is in high speed mode, the minimum time is 1 MCLK. If timer is not in high speed mode, the minimum time is 1 t_C.
8
Submit Documentation Feedback
Copyright © 2001–2013, Texas Instruments Incorporated
Product Folder Links: COP8AME9 COP8ANE9