COP8AME9_14 Datasheet, PDF (10/102 Pages) Texas Instruments – COP8AME9 8-Bit CMOS Flash Microcontroller with 8k Memory, Dual Op Amps, Virtual EEPROM, Temperature Sensor, 10-Bit A/D and Brownout Reset

COP8AME9, COP8ANE9
SNOS930F – MARCH 2001 – REVISED MARCH 2013
www.ti.com
Stand-alone Amplifier Electrical Characteristics (4.5V ≤ AV_CC ≤ 5.5V, −40°C ≤ T_A ≤ +85°C)
Datasheet min/max specification limits are ensured by design, test, or statistical analysis.
Parameter
Conditions
Min
Typ
Max
Units
Input Offset Voltage
-7
+7
mV
Input Common Mode Capacitance
10
pF
Common Mode Rejection Ratio
(CMRR)
0V ≤ V_CM ≤ V_CC
50
dB
Power Supply Rejection Ratio
(PSRR)
V_CM = V_CC/2
70
dB
Common Mode Voltage Range
(CMVR)
CMRR ≥ 45dB
-0.2
V_CC + 0.2
V
Large Signal Voltage Gain
R_L = 2k to V_CC/2,
V_CM = V_CC/2
70
85
dB
0.5 ≤ V_O ≤ V_CC - 0.5V
Output Swing High
R_L = 2k to V_CC/2,
Vid = 100 mV
V_CC - 70
mV
Output Swing Low
Output Short Circuit Current ⁽¹⁾
Output Short Circuit Current ⁽¹⁾
R_L = 2k to V_CC/2,
Vid = 100 mV
V_O = GND,
Vid = 100 mV
V_O = V_CC,
Vid = 100 mV
80
mV
20
mA
15
mA
Supply Current on AV_CC when
enabled
AV_CC = 5.5 V,
No Load
315
500
µA
Enable Time
15
µS
Disable Time
Slew Rate ⁽²⁾
Gain = 1, R_L = 10k,
C_L < 350 pF
Vin = 2V square wave
1
1.0
1.5
µS
V/µS
Unity Gain Frequency
Input Referred Voltage Noise
R_L = 2k to V_CC/2
2.0
Mhz
55
(1)
Total Harmonic Distortion (THD)
f = 1kHz, AV = 1, Vo = 2.2 Vpp,
R_L = 600Ω to V_CC/2
0.2
%
(1) Short circuit test is a momentary test. Extended period output short circuit may damage the device.
(2) Slew rate is the slower of the rising and falling slew rates.
10
Submit Documentation Feedback
Copyright © 2001–2013, Texas Instruments Incorporated
Product Folder Links: COP8AME9 COP8ANE9