HD64F3664BPV Datasheet, PDF (433/446 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer

Main Revisions and Additions in this Edition
Item
Page Revision (See Manual for Details)
Preface
vi, vii Amended
Notes
When using the on-chip emulator (E7, E8) for H8/3664
program development and debugging, the following
restrictions must be noted (the on-chip debugging
emulator (E7) can also be used).
1. The NMI pin is reserved for the E7 or E8, and
cannot be used.
2. Pins P85, P86, and P87 cannot be used. In order to
use these pins, additional hardware must be
provided on the user board.
3. Area H'7000 to H'7FFF is used by the E7 or E8, and
is not available to the user.
4. Area H'F780 to H'FB7F must on no account be
accessed.
5. When the E7 or E8 is used, address breaks can be
set as either available to the user or for use by the
E7 or E8. If address breaks are set as being used
by the E7 or E8, the address break control registers
must not be accessed.
6. When the E7 or E8 is used, NMI is an input/output
pin (open-drain in output mode), P85 and P87 are
input pins, and P86 is an output pin.
Figure 5.3 Typical Connection to
Crystal Resonator
Figure 5.5 Typical Connection to
Ceramic Resonator
78 to
80
Added
Note: Capacitances are reference values.
Figure 5.8 Typical Connection to
32.768-kHz Crystal Resonator
Rev. 6.00 Mar. 24, 2006 Page 403 of 412
REJ09B0142-0600