LAN9500 Datasheet, PDF (85/213 Pages) SMSC Corporation – USB 2.0 to 10/100 Ethernet Controller Promiscuous mode

LAN950x
FIGURE 5-23:
EEPROM EWDS CYCLE
tCSL
EECS
EECLK
EEDIO (OUTPUT)
1
0
0
0
0
EEDIO (INPUT)
EWEN (Erase/Write Enable): Enables the EEPROM for erase and write operations. The EEPROM will allow erase and
write operations until the “Erase/Write Disable” command is sent, or until power is cycled.
Note: The EEPROM device will power-up in the erase/write-disabled state. Any erase or write operations will fail
until an Erase/Write Enable command is issued.
FIGURE 5-24:
EEPROM EWEN CYCLE
t_CSL
EECS
EECLK
EEDIO (OUTPUT)
1
0
0
1
1
EEDIO (INPUT)
READ (Read Location): This command will cause a read of the EEPROM location pointed to by EPC Address
(EPC_ADDR). The result of the read is available in the E2P_DATA register.
 2010 - 2015 Microchip Technology Inc.
DS00001875A-page 85