LAN9500 Datasheet, PDF (114/213 Pages) SMSC Corporation – USB 2.0 to 10/100 Ethernet Controller Promiscuous mode

LAN950x
Figure 6-2 flowcharts PME operation while in Internal PHY mode. The following conditions hold:
EEPROM Configuration:
• GPIO PME Enable = 1 (enabled)
• GPIO PME Configuration = 0 (PME signaled via level on GPIO pin)
• GPIO PME Length = 0 (NA)
• GPIO PME Polarity = 1 (high level signals event)
• GPIO PME Buffer Type = 1 (Push-Pull)
• GPIO PME WOL Select = 0 (Magic Packet wakeup)
• GPIO10 Detection Select = 0 (Active-low detection)
• Power Method = 1 (self powered)
• MAC address for Magic Packet
PME signaling configuration (as determined by PHY Mode)
• GPIO0 signals PME
• GPIO1 is PME_MODE_SEL
Note: A POR occurring when PME_MODE_SEL = 1 and an EEPROM present with the GPIO PME Enable set
results in the device entering PME Mode.
DS00001875A-page 114
 2010 - 2015 Microchip Technology Inc.