PIC16F193X Datasheet, PDF (139/418 Pages) Microchip Technology – 28/40/44-Pin Flash-Based, 8-Bit CMOS Microcontrollers with LCD Driver and nanoWatt Technology

PIC16F193X/LF193X
11.2.7 ADC REGISTER DEFINITIONS
The following registers are used to control the
operation of the ADC.
REGISTER 11-1: ADCON0: A/D CONTROL REGISTER 0
U-0
—
bit 7
R/W-0/0
CHS4
R/W-0/0
CHS3
R/W-0/0
CHS2
R/W-0/0
CHS1
R/W-0/0
CHS0
R/W-0/0
GO/DONE
R/W-0/0
ADON
bit 0
Legend:
R = Readable bit
u = bit is unchanged
‘1’ = Bit is set
W = Writable bit
x = Bit is unknown
‘0’ = Bit is cleared
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
bit 7
bit 6-2
bit 1
bit 0
Unimplemented: Read as ‘0’
CHS<4:0>: Analog Channel Select bits
00000 = AN0
00001 = AN1
00010 = AN2
00011 = AN3
00100 = AN4
00101 = AN5
00110 = AN6
00111 = AN7
01000 = AN8
01001 = AN9
01010 = AN10
01011 = AN11
01100 = AN12
01101 = AN13
01110 = Reserved. No channel connected.
.
.
.
11100 = Reserved. No channel connected.
11101 = Temperature Reference from band gap
11110 = DAC output (aka CVREF output)
11111 = Fixed Voltage Reference (FVR) Buffer 1 Output
GO/DONE: A/D Conversion Status bit
1 = A/D conversion cycle in progress. Setting this bit starts an A/D conversion cycle.
This bit is automatically cleared by hardware when the A/D conversion has completed.
0 = A/D conversion completed/not in progress
ADON: ADC Enable bit
1 = ADC is enabled
0 = ADC is disabled and consumes no operating current
Note 1: See Section 10.0 “Fixed Voltage Reference” for more information.
© 2008 Microchip Technology Inc.
Preliminary
DS41364A-page 137