English
Language : 

S912XEP100J5MAG Datasheet, PDF (749/1324 Pages) Freescale Semiconductor, Inc – Features of the MC9S12XE-Family are listed here. Please see Table D-2.for memory options and Table D-2. for the peripheral features that are available on the different family members.
Chapter 20 Serial Communication Interface (S12SCIV5)
indicating that the received byte can be read. If the receive interrupt enable bit, RIE, in SCI control
register 2 (SCICR2) is also set, the RDRF flag generates an RDRF interrupt request.
20.4.6.3 Data Sampling
The RT clock rate. The RT clock is an internal signal with a frequency 16 times the baud rate. To adjust
for baud rate mismatch, the RT clock (see Figure 20-21) is re-synchronized:
• After every start bit
• After the receiver detects a data bit change from logic 1 to logic 0 (after the majority of data bit
samples at RT8, RT9, and RT10 returns a valid logic 1 and the majority of the next RT8, RT9, and
RT10 samples returns a valid logic 0)
To locate the start bit, data recovery logic does an asynchronous search for a logic 0 preceded by three logic
1s.When the falling edge of a possible start bit occurs, the RT clock begins to count to 16.
Start Bit
LSB
RXD
Samples 1 1 1 1 1 1 1 1 0
0
0
0000
Start Bit
Qualification
Start Bit
Verification
Data
Sampling
RT Clock
RT CLock Count
Reset RT Clock
Figure 20-21. Receiver Data Sampling
To verify the start bit and to detect noise, data recovery logic takes samples at RT3, RT5, and RT7.
Figure 20-17 summarizes the results of the start bit verification samples.
Table 20-17. Start Bit Verification
RT3, RT5, and RT7 Samples
000
001
010
011
100
101
110
111
Start Bit Verification
Yes
Yes
Yes
No
Yes
No
No
No
Noise Flag
0
1
1
0
1
0
0
0
If start bit verification is not successful, the RT clock is reset and a new search for a start bit begins.
MC9S12XE-Family Reference Manual Rev. 1.25
Freescale Semiconductor
749