MC908GZ60CFUE Datasheet, PDF (272/352 Pages) Freescale Semiconductor, Inc – Standard features, Features of the CPU08

Timer Interface Module (TIM1)
TSTOP — TIM1 Stop Bit
This read/write bit stops the TIM1 counter. Counting resumes when TSTOP is cleared. Reset sets the
TSTOP bit, stopping the TIM1 counter until software clears the TSTOP bit.
1 = TIM1 counter stopped
0 = TIM1 counter active
NOTE
Do not set the TSTOP bit before entering wait mode if the TIM1 is required
to exit wait mode. Also, when the TSTOP bit is set and the timer is
configured for input capture operation, input captures are inhibited until the
TSTOP bit is cleared.
TRST — TIM1 Reset Bit
Setting this write-only bit resets the TIM1 counter and the TIM1 prescaler. Setting TRST has no effect
on any other registers. Counting resumes from $0000. TRST is cleared automatically after the TIM1
counter is reset and always reads as 0. Reset clears the TRST bit.
1 = Prescaler and TIM1 counter cleared
0 = No effect
NOTE
Setting the TSTOP and TRST bits simultaneously stops the TIM1 counter
at a value of $0000.
PS[2:0] — Prescaler Select Bits
These read/write bits select one of the seven prescaler outputs as the input to the TIM1 counter as
Table 18-1 shows. Reset clears the PS[2:0] bits.
Table 18-1. Prescaler Selection
PS2
PS1
PS0
0
0
0
0
0
1
0
1
0
0
1
1
1
0
0
1
0
1
1
1
0
1
1
1
TIM1 Clock Source
Internal bus clock ÷ 1
Internal bus clock ÷ 2
Internal bus clock ÷ 4
Internal bus clock ÷ 8
Internal bus clock ÷ 16
Internal bus clock ÷ 32
Internal bus clock ÷ 64
Not available
MC68HC908GZ60 • MC68HC908GZ48 • MC68HC908GZ32 Data Sheet, Rev. 6
272
Freescale Semiconductor