MC908GZ60CFUE Datasheet, PDF (262/352 Pages) Freescale Semiconductor, Inc – Standard features, Features of the CPU08

Timebase Module (TBM)
17.7 Timebase Control Register
The timebase has one register, the timebase control register (TBCR), which is used to enable the
timebase interrupts and set the rate.
Address: $001C
Bit 7
6
5
4
3
2
1
Bit 0
Read: TBIF
0
TBR2
TBR1
TBR0
TBIE
TBON
R
Write:
TACK
Reset: 0
0
0
0
0
0
0
0
= Unimplemented
R = Reserved
Figure 17-2. Timebase Control Register (TBCR)
TBIF — Timebase Interrupt Flag
This read-only flag bit is set when the timebase counter has rolled over.
1 = Timebase interrupt pending
0 = Timebase interrupt not pending
TBR2–TBR0 — Timebase Divider Selection Bits
These read/write bits select the tap in the counter to be used for timebase interrupts as shown in
Table 17-1.
NOTE
Do not change TBR2–TBR0 bits while the timebase is enabled (TBON = 1).
TACK— Timebase Acknowledge Bit
The TACK bit is a write-only bit and always reads as 0. Writing a 1 to this bit clears TBIF, the timebase
interrupt flag bit. Writing a 0 to this bit has no effect.
1 = Clear timebase interrupt flag
0 = No effect
TBIE — Timebase Interrupt Enabled Bit
This read/write bit enables the timebase interrupt when the TBIF bit becomes set. Reset clears the
TBIE bit.
1 = Timebase interrupt is enabled.
0 = Timebase interrupt is disabled.
TBON — Timebase Enabled Bit
This read/write bit enables the timebase. Timebase may be turned off to reduce power consumption
when its function is not necessary. The counter can be initialized by clearing and then setting this bit.
Reset clears the TBON bit.
1 = Timebase is enabled.
0 = Timebase is disabled and the counter initialized to 0s.
MC68HC908GZ60 • MC68HC908GZ48 • MC68HC908GZ32 Data Sheet, Rev. 6
262
Freescale Semiconductor