|
LAN9303 Datasheet, PDF (159/366 Pages) SMSC Corporation – Small Form Factor Three Port 10/100 Managed Ethernet Switch with Single MII/RMII/Turbo MII | |||
|
◁ |
Small Form Factor Three Port 10/100 Managed Ethernet Switch with Single MII/RMII/Turbo MII
Datasheet
13.2.4.5 Switch Fabric CSR Interface Command Register (SWITCH_CSR_CMD)
Offset:
1B0h
Size:
32 bits
This read/write register is used in conjunction with the Switch Fabric CSR Interface Data Register
(SWITCH_CSR_DATA) to control the read and write operations to the various Switch Fabric CSRâs.
Refer to Section 13.4, "Switch Fabric Control and Status Registers," on page 212 for details on the
registers indirectly accessible via this register.
BITS
DESCRIPTION
31
30
29
28
27:20
CSR Busy (CSR_BUSY)
When a 1 is written to this bit, the read or write operation (as determined by
the R_nW bit) is performed to the specified Switch Fabric CSR in CSR
Address (CSR_ADDR[15:0]). This bit will remain set until the operation is
complete, at which time the bit will clear. In the case of a read, the clearing
of this bit indicates to the Host that valid data can be read from the Switch
Fabric CSR Interface Data Register (SWITCH_CSR_DATA). The
SWITCH_CSR_CMD and SWITCH_CSR_DATA registers should not be
modified until this bit is cleared.
Read/Write (R_nW)
This bit determines whether a read or write operation is performed by the
Host to the specified Switch Engine CSR.
0: Write
1: Read
Auto Increment (AUTO_INC)
This bit enables/disables the auto increment feature.
When this bit is set, a write to the Switch Fabric CSR Interface Data Register
(SWITCH_CSR_DATA) register will automatically set the CSR Busy
(CSR_BUSY) bit. Once the write command is finished, the CSR Address
(CSR_ADDR[15:0]) will automatically increment.
When this bit is set, a read from the Switch Fabric CSR Interface Data
Register (SWITCH_CSR_DATA) will automatically increment the CSR
Address (CSR_ADDR[15:0]) and set the CSR Busy (CSR_BUSY) bit. This
bit should be cleared by software before the last read from the
SWITCH_CSR_DATA register.
0: Disable Auto Increment
1: Enable Auto Increment
Note: This bit has precedence over the Auto Decrement (AUTO_DEC) bit
Auto Decrement (AUTO_DEC)
This bit enables/disables the auto decrement feature.
When this bit is set, a write to the Switch Fabric CSR Interface Data Register
(SWITCH_CSR_DATA) will automatically set the CSR Busy (CSR_BUSY)
bit. Once the write command is finished, the CSR Address
(CSR_ADDR[15:0]) will automatically decrement.
When this bit is set, a read from the Switch Fabric CSR Interface Data
Register (SWITCH_CSR_DATA) will automatically decrement the CSR
Address (CSR_ADDR[15:0]) and set the CSR Busy (CSR_BUSY) bit. This
bit should be cleared by software before the last read from the
SWITCH_CSR_DATA register.
0: Disable Auto Decrement
1: Enable Auto Decrement
RESERVED
TYPE
R/W
SC
R/W
R/W
R/W
RO
DEFAULT
0b
0b
0b
0b
-
SMSC LAN9303/LAN9303i
159
DATASHEET
Revision 1.3 (08-27-09)
|
▷ |