English
Language : 

PIC16F707 Datasheet, PDF (66/284 Pages) Microchip Technology – 40/44-Pin, Flash Microcontrollers with nanoWatt XLP and mTouch™ Technology
PIC16F707/PIC16LF707
REGISTER 6-17: TRISE: PORTE TRI-STATE REGISTER
U-0
—
bit 7
U-0
U-0
U-0
R-1
—
—
—
TRISE3
R/W-1
TRISE2
R/W-1
TRISE1
R/W-1
TRISE0
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7-4
bit 3
bit 2-0
Unimplemented: Read as ‘0’
TRISE3: RE3 Port Tri-state Control bit
This bit is always ‘1’ as RE3 is an input only
TRISE<2:0>: RE<2:0> Tri-State Control bits(1)
1 = PORTE pin configured as an input (tri-stated)
0 = PORTE pin configured as an output
REGISTER 6-18: ANSELE: PORTE ANALOG SELECT REGISTER
U-0
—
bit 7
U-0
U-0
U-0
U-0
R/W-1
—
—
—
—
ANSE2
R/W-1
ANSE1
R/W-1
ANSE0
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7-3
bit 2-0
Unimplemented: Read as ‘0’
ANSE<2:0>: Analog Select between Analog or Digital Function on Pins RE<2:0>, respectively
0 = Digital I/O. Pin is assigned to port or digital special function.
1 = Analog input. Pin is assigned as analog input(1). Digital input buffer disabled.
Note 1: When setting a pin to an analog input, the corresponding TRIS bit must be set to Input mode in order to
allow external control of the voltage on the pin.
6.6.2 PIN DESCRIPTIONS
Each PORTE pin is multiplexed with other functions. The
pins and their combined functions are briefly described
here. For specific information about individual functions
such as the SSP, I2C or interrupts, refer to the appropriate
section in this data sheet.
6.6.2.1 RE0/AN5/CPSA5
These pins are configurable to function as one of the
following:
• General purpose I/O
• Analog input for the ADC
• Capacitive sensing input
6.6.2.2
RE1/AN6/CPSA6
These pins are configurable to function as one of the
following:
• General purpose I/O
• Analog input for the ADC
• Capacitive sensing input
6.6.2.3 RE2/AN7/CPSA7
These pins are configurable to function as one of the
following:
• General purpose I/O
• Analog input for the ADC
• Capacitive sensing input
DS41418A-page 66
Preliminary
 2010 Microchip Technology Inc.