PIC16F707 Datasheet, PDF (215/284 Pages) Microchip Technology – 40/44-Pin, Flash Microcontrollers with nanoWatt XLP and mTouch™ Technology

PIC16F707/PIC16LF707
TABLE 25-1: CLOCK OSCILLATOR TIMING REQUIREMENTS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +125°C
Param
No.
Sym.
Characteristic
Min. Typ† Max. Units
Conditions
OS01 FOSC External CLKIN Frequency⁽¹⁾
DC
—
37
kHz LP Oscillator mode
DC
—
4
MHz XT Oscillator mode
DC
—
20
MHz HS Oscillator mode
Oscillator Frequency⁽¹⁾
DC
—
20
— 32.768 —
MHz EC Oscillator mode
kHz LP Oscillator mode
0.1
—
4
MHz XT Oscillator mode
1
—
4
MHz HS Oscillator mode, VDD 2.7V
1
—
20
MHz HS Oscillator mode, VDD 2.7V
OS02 TOSC External CLKIN Period⁽¹⁾
DC
—
27
—
4
MHz RC Oscillator mode

s LP Oscillator mode
250
—

ns XT Oscillator mode
50
—

ns HS Oscillator mode
Oscillator Period⁽¹⁾
50
—

—
30.5
—
ns EC Oscillator mode
s LP Oscillator mode
250
— 10,000 ns XT Oscillator mode
250
—
1,000
ns HS Oscillator mode, VDD 2.7V
50
—
1,000
ns HS Oscillator mode, VDD 2.7V
OS03 TCY
Instruction Cycle Time⁽¹⁾
250
—
—
ns RC Oscillator mode
200
TCY
DC
ns TCY = 4/FOSC
OS04* TosH, External CLKIN High,
TosL External CLKIN Low
2
—
100
—
—
s LP oscillator
—
ns XT oscillator
20
—
—
ns HS oscillator
OS05* TosR, External CLKIN Rise,
TosF External CLKIN Fall
0
—

ns LP oscillator
0
—

ns XT oscillator
0
—

ns HS oscillator
*
†
Note 1:
These parameters are characterized but not tested.
Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Instruction cycle period (TCY) equals four times the input oscillator time base period. All specified values are based on
characterization data for that particular oscillator type under standard operating conditions with the device executing
code. Exceeding these specified limits may result in an unstable oscillator operation and/or higher than expected current
consumption. All devices are tested to operate at “min” values with an external clock applied to OSC1 pin. When an
external clock input is used, the “max” cycle time limit is “DC” (no clock) for all devices.
 2010 Microchip Technology Inc.
Preliminary
DS41418A-page 215