|
RG82845SL5YQ Datasheet, PDF (83/148 Pages) Intel Corporation – Intel® 845 Chipset: 82845 Memory Controller Hub (MCH) for SDR | |||
|
◁ |
Register Description
R
3.6.4
PCISTS1âPCI-PCI Status Register (Device 1)
Address Offset:
Default Value:
Access:
Size:
06â07h
00A0h
RO, R/WC
16 bits
PCISTS1 is a 16-bit status register that reports the occurrence of error conditions associated with
primary side of the âvirtualâ PCI-PCI bridge embedded n the MCH. Since this device does not
physically reside on PCI_A, it reports the optimum operating conditions so that it does not restrict
the capability of PCI_A.
Bit
Descriptions
15
Detected Parity Error (DPE1)âRO. Not Implemented; Hardwired to 0.
14
Signaled System Error (SSE1)âR/WC.
0 =Software clears this bit by writing a 1 to it.
1 =MCH device 1 generated an SERR message over the hub interface for any enabled Device
1 error condition. Device 1 error conditions are enabled in the ERRCMD, PCICMD1 and
BCTRL1 registers. Device 1 error flags are read/reset from the ERRSTS and SSTS1
register.
13
Received Master Abort Status (RMAS1)âRO. Not Implemented; Hardwired to 0.
12
Received Target Abort Status (RTAS1)âRO. Not Implemented; Hardwired to 0.
11
Signaled Target Abort Status (STAS1)âRO. Not Implemented; Hardwired to 0.
10:9 DEVSEL# Timing (DEVT1)âRO. Hardwired to 00b. Indicate that the device 1 uses the fastest
possible decode.
8
Data Parity Detected (DPD1). Not Implemented; Hardwired to 0.
7
Fast Back-to-Back (FB2B1)âRO. Hardwired to 1. The AGP port always supports fast back to
back transactions.
6
Reserved.
5
66 MHz Capability (CAP66)âRO. Hardwired to 1. Indicates that the AGP port is 66 MHz
capable.
4:0
Reserved.
Intel® 82845 MCH for SDR Datasheet
83
|
▷ |