CN8478 Datasheet, PDF (130/221 Pages) Conexant Systems, Inc – Multichannel Synchronous Communications Controller (MUSYCC)

5.0 Memory Organization
5.2 Descriptors
Table 5-31. Interrupt Descriptor (4 of 4)
CN8478/CN8474A/CN8472A/CN8471A
Multichannel Synchronous Communications Controller (MUSYCC™)
Bit
Field
Field
Name
Value
Interrupt
Name
Description
14
GRP[2]
MSB of Group number.
13:0 BLEN[13:0]
This field is relevant when EVENT field is EOB (Rx and Tx)
or EOM (Rx only). For Rx, it is equal to the number of octets
received. For Tx, it is the size of the buffer length targeted
for transmission and not necessarily the number of octets
transmitted. This field is 0 all other times.
NOTE(S):
(1) _{Receive EOB and Receive EOM are concurrent events and are reported as a single interrupt; whereas Transmit EOB and EOM}
are separate events and are reported as separate interrupts (two interrupt events).
(2) _{Interrupt names are also reported in an error field within a receive Buffer Status Descriptor which indicates the transfer status}
of a message currently being processed on a channel. The order of appearance in shared memory of a Buffer Status Descriptor
and an Interrupt Descriptor carrying the same error condition information is indeterminate. The host should confirm that both
an Interrupt Descriptor and a Buffer Status Descriptor reports the error condition.
(3) _{Previously existed in bit 14 of 8474, 8472.}
5.2.5.3 Interrupt Status
Descriptor
The Interrupt Status Descriptor is located in a fixed position within MUSYCC’s
internal registers. MUSYCC updates this descriptor after each transfer of
interrupt descriptors from its internal queue to the Interrupt Queue in shared
memory. The host must read this descriptor from MUSYCC registers before it
processes any interrupts. The interrupt status descriptor’s contents are reset on
hardware reset, soft chip reset, or when any field in the Interrupt Queue
Descriptor is modified.
Table 5-32 lists the details of the Interrupt Status Descriptor.
Table 5-32. Interrupt Status Descriptor
Bit
Field
Name
Value
Description
31
30:16
RSVD
NEXTINT[14:0]
15
INTFULL
14:0 INTCNT[14:0]
0
Reserved.
Next Interrupt Index. 15-bit dword index from start of Interrupt Queue up to where the
host has serviced Interrupt Descriptors.
The host can read this value to get the location of the first unserviced descriptor in
the queue. As the queue is circular, care must be taken to ensure roll-over cases at
beginning and end of queue. Only the host updates this value. The NEXTINT is a
read/write bit field. This is a 0-based number and equals the dword offset from Interrupt
Queue Pointer.
0
Interrupt Queue Not Full—shared memory.⁽¹⁾
1
Interrupt Queue Full—shared memory.⁽¹⁾
Interrupt Count. 15-bit value indicates the number of interrupts pushed into the
Interrupt Queue since the last reading of the Interrupt Status Descriptor. All writes to
this bit field register are ignored.
NOTE(S):
(1) _{The INTFULL status is read—cleared bit field.}
5-44
Conexant
100660E