SM320F2808-EP Datasheet, PDF (30/118 Pages) Texas Instruments – Digital Signal Processors

SM320F2808-EP, SM320F2806-EP
SM320F2801-EP
Digital Signal Processors
SGLS316A – MARCH 2006 – REVISED FEBRUARY 2007
PF2:
eCAP:
eQEP:
SYS:
SCI:
SPI:
ADC:
I²C:
Enhanced Capture Module and Registers
Enhanced Quadrature Encoder Pulse Module and Registers
System Control Registers
Serial Communications Interface (SCI) Control and RX/TX Registers
Serial Port Interface (SPI) Control and RX/TX Registers
ADC Status, Control, and Result Register
Inter-Integrated Circuit Module and Registers
www.ti.com
3.2.17 General-Purpose Input/Output (GPIO) Multiplexer
Most of the peripheral signals are multiplexed with general-purpose input/output (GPIO) signals. This
enables the user to use a pin as GPIO if the peripheral signal or function is not used. On reset, GPIO pins
are configured as inputs. The user can individually program each pin for GPIO mode or peripheral signal
mode. For specific inputs, the user can also select the number of input qualification cycles. This is to filter
unwanted noise glitches. The GPIO signals can also be used to bring the device out of specific low-power
modes.
3.2.18 32-Bit CPU-Timers (0, 1, 2)
CPU-Timers 0, 1, and 2 are identical 32-bit timers with presettable periods and with 16-bit clock
prescaling. The timers have a 32-bit count down register, which generates an interrupt when the counter
reaches zero. The counter is decremented at the CPU clock speed divided by the prescale value setting.
When the counter reaches zero, it is automatically reloaded with a 32-bit period value. CPU-Timer 2 is
reserved for Real-Time OS (RTOS)/BIOS applications. CPU-Timer 1 is also reserved for Texas
Instruments system functions. CPU-Timer 2 is connected to INT14 of the CPU. CPU-Timer 1 can be
connected to INT13 of the CPU. CPU-Timer 0 is for general use and is connected to the PIE block.
3.2.19 Control Peripherals
The 280x devices support the following peripherals which are used for embedded control and
communication:
ePWM:
eCAP:
eQEP:
ADC:
The enhanced PWM peripheral supports independent/complementary PWM generation,
adjustable dead-band generation for leading/trailing edges, latched/cycle-by-cycle trip
mechanism. Some of the PWM pins support HRPWM features.
The enhanced capture peripheral uses a 32-bit time base and registers up to four
programmable events in continuous/one-shot capture modes.
This peripheral can also be configured to generate an auxiliary PWM signal.
The enhanced QEP peripheral uses a 32-bit position counter, supports low-speed
measurement using capture unit and high-speed measurement using a 32-bit unit timer.
This peripheral has a watchdog timer to detect motor stall and input error detection logic
to identify simultaneous edge transition in QEP signals.
The ADC block is a 12-bit converter, single ended, 16-channels. It contains two
sample-and-hold units for simultaneous sampling.
3.2.20 Serial Port Peripherals
30
Functional Overview
Submit Documentation Feedback