E702289_SH7290 Datasheet, PDF (37/252 Pages) Renesas Technology Corp – SH7290 E10A Emulator

Figure 2.4 Connecting the User System Interface Cable to the User System
when the 14-pin Straight Type Connector is Used
Notes: 1. To connect the signals output from the Hitachi-UDI port connector, refer to
the device pin alignment.
2. To remove the user system interface cable from the user system, pull the tab
on the connector upward.
3. The range of frequencies that the Hitachi-UDI operates at is different
according to the devices used. For details, refer to section 6.5.4, Notes on
Using the JTAG Clock (TCK) and AUD Clock (AUDCK).
4. Connect the Hitachi-UDI signals from the Hitachi-UDI port connector directly
to the device.
5. When developing user systems, do not connect the TDI and TDO signals of the
device to the boundary scan loop, or separate them by using a switch (figure
2.5).
13