E702289_SH7290 Datasheet, PDF (235/252 Pages) Renesas Technology Corp – SH7290 E10A Emulator

6.5.7 Notes on Setting the BREAKCONDITION_SET Command
1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Break
Condition 2 are disabled.
2. Executing the instructions at the addresses containing BREAKPOINT invalidates the channel
2 settings of the BREAKCONDITION_SET command. Make sure not to set BREAKPOINTs
at addresses where the channel 2 settings of the BREAKCONDITION_SET command are to
be satisfied.
3. If a PC break address condition is set to the slot instruction after a delayed branch instruction,
user program execution cannot be terminated before the slot instruction execution even when
the PC option is specified in the <addrcycle> parameter; execution stops before the branch
destination instruction.
4. When a Break Condition is satisfied, emulation may stop after two or more instructions have
been executed.
6.5.8 Notes on Setting the [Trace] Window
When a completion-type exception occurs during exception branch acquisition, the next address to
the address in which an exception occurs is acquired.
6.5.9 Notes on Setting the UBC_MODE Command
In the [Configuration] dialog box, if [User] is set while the [UBC mode] list box has been set, the
STEP-type commands that use Break Condition2 for implementation cannot be used. If these
commands are used, the message box shown in figure 6.13 is displayed.
Figure 6.13 [HDI] Message Box
211