E702289_SH7290 Datasheet, PDF (248/252 Pages) Renesas Technology Corp – SH7290 E10A Emulator

 File specification by commands
The current directory may be altered by file specifications in commands. Absolute paths
are recommended to be used to specify the files in a command file so that the current
directory alteration is not affected.
Example:
FILE_LOAD C:\\HEW\\HDI5\\E10A\\7290\\TUTORIAL\\TUTORIAL
\\DEBUG\\TUTORIAL.ABS
9. About Hitachi Debugging Interface User’s Manual
This version of HDI does not support section 10, Selecting Functions, written in Hitachi
Debugging Interface User’s Manual.
10. Initiating HDI
When the emulator is initiated by using another card emulator after it has been initiated by
using the PCI card emulator, delete the [TARGET] line from the C:\windows\HDI.INI file.
11. Usage with Another Version of HDI
 Automatic load of session files
Since the emulator cannot use another version of HDI, re-install this HDI whenever
another version has been previously installed.
If another version has been used, initiate this HDI with “Run” as follows without using the
session files.
<Directory path name in which HDI is installed>\hdi /n (RET)
/n initiates the HDI without loading the recently used session files.
If there is another session file in the different debug platform, the following error message
is displayed:
invalid target system: <recently used debug platform name>
12. [Select Function] Dialog Box
This HDI does not support BREAKPOINT setting in the [Select Function] dialog box
(described in section 10, Selecting Functions, in the Hitachi Debugging Interface User's
Manual).
13. Memory Save During User Program Execution
Do not execute memory save or verifying during user program execution.
14. Load of Motorola S-type Files
This HDI does not support Motorola S-type files with only the CR code (H'0D) at the end of
each record. Load Motorola S-type files with the CR and LF codes (H'0D0A) at the end of
each record.
224